Bradford-white M-1-2U6SS User Manual

238-44933-00E REV 03/12 TWO GALLON ELECTRIC WATER HEATER THE WARRANTY ON THIS WATER HEATER IS IN EFFECT ONLY WHEN THE WATER HEATER IS INSTALLED A

10Electrical Connections continued- Recommended Fuse size Voltage Max. Watts 120v 208v 240v 277v 480v 1000 15A 10A 10A 10A 10A 1250 15A 10A 1

11Thermostat Adjustment The temperature of the water can be changed by adjusting the thermostat(s). Before any work is done on the water heater, d

12Maintenance continued- Shut off the electric power whenever the water supply to the water heater is off. Shut off the electric power and water su

13Maintenance continued- 4. If the combination temperature and pressure relief valve on the appliance discharges periodically, this may be due to t

14Maintenance continued- READ THE WARRANTY FOR A FULL EXPLANATION OF THE LENGTH OF TIME THAT PARTS AND THE WATER HEATER ARE WARRANTED. Complete the

15NOTES

16NOTES

2CONGRATULATIONS! You have just purchased one of the finest water heaters on the market today! This installation, operation and instruction manual

3GENERAL INFORMATION This electric water heater’s design is certified by INTERTEK (ETL) and listed in accordance with UL 174. CETL listed in accorda

4General Information continued- A sacrificial anode is used to extend tank life. Removal of this anode, for any reason, will nullify the warranty.

5Locating The Water Heater continued- Some models are not equipped with a drain valve. For those models, install a drain tee in the cold water inlet

6Water Connections NOTE: BEFORE PROCEEDING WITH THE INSTALLATION, CLOSE THE MAIN WATER SUPPLY VALVE. After shutting the main water supply valve, o

7Water Connections continued- WARNING For protection against excessive temperatures and pressure, install temperature and pressure protective equipm

8(52°C) can cause severe burns are at highest risk of beingChildren, disabled and elderlyinstantly or death from scalds.Water temperature over 125°F

9Water Connections continued- The hot and cold water connections are identified on the top of the water heater. Connect the hot and cold water line