Bradford White EVERHOT TG-237E-N(X)A Instruction Manual download pdf (Page 35)

°F

Set Temperature

In Use

Priority

e n d l e s s h o t w a t e r s y s t e m

CAUTION: Hotter water increases the risk

of scald injury. Before changing temperature

setting, see instruction manual.

C O R P O R A T I O N

Temperature

Display

In Use

Indicator

Priority

Button

Priority

Indicator

Thermostat

Figure 13. Remote Control and the Description of Functions on All Controls.

Residential Control, p/n 239-47806-00

Commercial Control, p/n 239-47805-00

Installation of Control(s)

1. The controls may be wired in parallel only.

2. Mark the holes on the wall using the control mounting plate and drill two mounting holes using a

3/32” (2.4 mm) drill bit and a clearance hole for the cable using a ¼” (6.4 mm) drill bit.

3. Run the cable from the control to the water heater or another control, which ever is closer or more

convenient.

4. Remove the face plate from the control by inserting a screwdriver in the slot and twisting open.

5. Connect the cable to the terminal screws of the control.

6. Mount the control to the wall using the holes drilled and with the screws supplied. Note: Plastic

wall anchors may be required if the control is not located over a stud when mounting on

wallboard.

Note: If the cable cannot be run inside the wall cavity, then the plastic knockout should be removed from

the top or bottom of the control to allow flush mounting with the wall.

7. Disconnect the power from the water heater and remove the front cover.

securing screw

1-21/32"

3-5/16"

securing screw

wiring hole

Figure 14. Outline of Remote Control's Mounting Plate.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 71 72

No comments

Bradford White EVERHOT TG-237E-N(X)A Instruction Manual Page 35