Bradford-white DS1-50S6FSX User Manual download pdf (Page 21)

Installation (Vent-Air Intake System Installation) continued-

9. From outside the building, slide the five (5) inch (12.7 cm) diameter

telescopic tube through the opening in the wall until the outer wall mount

plate is flush with the wall (See Figure 12).

Figure 12

10. Using the supplied special RTV silicone sealant, apply a bead one (1)

inch (2.5 cm) from the end of the three (3) inch (7.6 cm) diameter tube

that is part of the vent-air intake terminal. Slide the direct vent-air

intake terminal into the three (3) inch (7.6 cm) diameter telescopic tube

that extends through the wall and position it so it is flush with the outer

wall mount plate. Make sure that the rain guard and the word “HOT” on

the end of the direct vent-air intake terminal are oriented properly.

Secure the direct vent-air intake terminal to the outer wall mount plate

and wall with four (4) #10 x 1 inch screws (supplied) (See Figure 13).

Note: Certain construction of walls may require the use of different type

of anchoring means than supplied. DO NOT modify the direct vent-air

intake terminal or outer wall mount plate.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

No comments

Bradford-white DS1-50S6FSX User Manual Page 21